Quick help notes on common questions:
(Question)
Ford spark plug blow out M14x1.25 need second
repair?
If you have a Ford vehicle and the spark plug hole was previously repaired
and the insert blew out again. The failed insert should .663 inches on the O.D
or 16.8mm or SMALLER use our Ford triton kit
p/n 6605553 click here:
If your insert is LARGER than .663 inches
you need the Ford Triple oversized repair kit
p/n 6605600 click here:
If you are repairing a Ford 3 valve M16x1.5 Ford spark plug see link
3 valve ford spark plug click here.
(Question) I have a Honda, Acura, BMW, Toyota with a stripped or blown out spark plug what
kit do I need?
Typically these spark plugs are a 3/4 reach washer seat. Because the spark plugs
are normally deep down in
the hole use our
kit p/n 6604412E-111 click here:
(Question)
I have a Toyota head bolt that stripped out what
kit do I need?
We see a lot of problems with the Toyota Camry and Rav 4 and others with 3 head
bolts stripping near the back of the head.
Check your bolt size it should be a M11x1.5 we offer
Toyota Approved kit p/n 6602200 click here:
We suggest doing all 10 head bolt holes so the head torques evenly.
(Question)
What kit do I need for my Honda or Acura oil drain
pan?
The size of the drain plug should be M14x1.5 check to be
sure.
If the oil pan had an oversized drain plug the plug O.D should not be larger
than the drill in our kit.
The drill included in the kit is .578 inches or 37/64 use
p/n 6601415C kit click here:
The drill has a square drive you can use a 1/2 inch 12 point socket to turn this
drill.
See link on 12 point sockets here: